Dynamic outputs
The dynamic part of the sensor signal is output as scaled value.
Scaled d.c. outputs
The DC part of the sensor signal is proportional to the distance between sensor and measuring target and is output as standard dc signal NGL (see section 4.2.4).
Signal conditioning for characteristical values
Before converting from analog to digital, the input signals are scaled and filtered by matching amplifier, range amplifier, high-pass and low-pass filter.
Current outputs of characteristical values
Calculation of characteristical values and evaluation depend on the functions de fined during the configuration.
Signal outputs EO 1 / EO 2
Voltage output O...10V. In the dual channel mode the current outputs are as signed to the relevant characteristical value. For the operating modes Smax and SPPmax outputs of single channel values. Measuring range and evaluation corre sponds to the characteristical values. Depending on application and configuration the outputs EO may be used for com bination with other values or for indications. open-circuit and short-circuit proof, non-reactive.
Signal inputs EI1 / EI2
Inputs for single channel values 0...+10 V for connection to EO-outputs.
Signal input KEY
The key pulse is required to control the internal measuring procedure for the sig nal analysis.
Add: Building F05, High-tech Software Park, Xiamen City, Fujian Province
Tel: 0592-5211302
Mobile: 17750019513 (WhatsApp)
Email: yy4291644@gmail.com
ivy@kongjiangauto.com
Website: https://www.abb-sis.com