MVME55006E P/N: 6806800A37L Installation and Use Motorola

  PMC mode is backwards compatible with the MVME5100 and is accomplished by configuring the on-board jumpers.

Getting Started

This section provides an overview of the steps necessary to install and power up the MVME55006E and a brief section on unpacking and ESD precautions.

Overview of Startup Procedures

The following table lists the things you will need to do before you can use this board and tells where to find the information you need to perform each step. Be sure to read this entire chapter, including all caution and warning notes, before you begin

Unpacking Guidelines

Unpack the equipment from the shipping carton. Refer to the packing list and verify that all items are present. Save the packing material for storing and reshipping of equipment. If the shipping carton is damaged upon receipt, request that the carrier’s agent be present during the unpacking and inspection of the equipment.

Configuring the Hardware

 This section discusses certain hardware and software tasks that may need to be performed 

prior to installing the board in a chassis.

To produce the desired configuration and ensure proper operation of the MVME55006E, you may need to carry out certain hardware modifications before installing the module. Most options on the MVME55006E are software configurable. Configuration changes are made by setting bits in control registers after the board is installed in a system. Jumpers and switches are used to control those options that are not software configurable. These settings are described further on in this section. If you are resetting the board  jumpers or switches from their default settings, it is important to verify that all settings are reset properly.