HONEYWELL 51401291-100 board card

HONEYWELL 5140 1291-100 board card

MONITOR OPERATION

The Enhanced Micro TDC3000 may be using one of following types of monitors:

• IDEK 21–inch Multiscan Color Monitor (older monitor Model MF-5221).  Section

5.4.1 explains the analog, rotary-type screen control knobs.

• IDEK 21–inch Vision Master Monitor (newer monitor Model MF-8221).  Section

5.4.2 explains the digital, push-button screen controls.

• HITACHI 21–inch Color Monitor (Model HM-4821-D).  Section 5.4.3 explains

the screen controls.  This monitor meets CE requirements.  It must be ordered

separately using model number MX-MTMA21.

The newer IDEK monitor is essentially identical to the older monitor including the

touchscreen option.  There are small physical differences between them primarily in the

layout and location of the screen controls.  The new monitor has its screen controls

mounted inside a recessed, sliding tray (drawer) located below the screen.  The screen

controls on the new monitor cannot be accessed once the drawer is closed (pushed in).  The

overall dimensions of the newer monitor are slightly larger than the older monitor.

Electrically, the video cable plug and pinning are identical in both.

Both IDEK monitors have an optional touchscreen (infrared touchscreen frame with plastic

bezel assembly) which are physically different.  The touchscreen option for the newer

monitor has 4 mounting ‘buttonholes’ (two on each side), and is only compatible with the

newer monitor.  The older monitor has 2 ‘buttonholes’ (one on each side).  The

touchscreen controller (electronics) and cable for the new monitor is identical to the older

monitor and can be easily transferred.

Table 5-1 shows the touchscreen hardware used with each monitor.  The only difference

between the two IDEK monitors is the larger Bezel for the newer IDEK Model 8821.  The

Hitachi uses the same touchscreen frame as the IDEK monitors.

Table 5-1 — Touchscreen Hardware Vs  Monitor Used

Touchscreen

Components

Hitachi

HM-4821-D

IDEK

8221

51197021-100

T/S Controller

51196363-100

IDEK

5221

51196075-100

MITSUBISHI

HC3905ATK

51195652-100

Cable: EPDGP I/O

to Controller

51197005-100 51197005-100 51197005-100

51302287-100 51302287-100 51302287-100 51306150-100

TS Power Cable

Cable: Controller to

Touchscreen

51302297-100 51302297-100 51302297-100 51306151-100

TS Data Cable

Touchscreen w/Bezel 51197022-100Ã 51197019-100Ã 51197007-100Ã 51195992-100

Bezel only

51197022-300Â 51197019-200¬

51197022-400 51197019-300¬

Bezel mounting

buttons-pkg of 4

Notes:

¬ These two items are required when moving a touchscreen from an IDEK model 5221 to a IDEK model 8221.

The IDEK 8221 requires a slightly larger plastic bezel housing.  The same touchscreen (sensor) frame is

used in both IDEKs and the Hitachi.  The four stick on buttons physically secure the touchscreen to the

monitor.- These cables go from the touchscreen to the I/O card in the node chassis.

 Includes the 4 mounting buttons.  This Bezel will adapt either IDEK touchscreen to fit the Hitachi monitor

à These assemblies all contain the same touchscreen.  Only the Bezel is different