DS200UCIAG2A UC2000 motherboard

Part Number DS200UCIAG2A Manufacturer General Electric Country of Manufacture As Per GE Manufacturing Policy Series Mark VI/VIe Function Module Availability In StockDS200UCIAG2A is a UC2000 Motherboard manufactured and designed by General Electric as part of the EX2000 Series used in GE Excitation turbine control systems. The main printed circuit board in the Innovation Series controller is called the UCIA. It has connectors that allow other boards, including the UCPB and IC660ELB912G (GENI), to be mounted. One jumper, JP1, which is solely used for manufacturing tests, is included on the UCIA board. When the process specifies, test points TP1 and TP2 are used for diagnostics. LEDs chosen by the process software make up DN1. The fan on the UCPB board is powered by 5 V through the fan connector (P14). It is used to supply the connectors necessary for attaching the UCPB CPU daughter board, the PANA ARCNET no-LAN driver board, up to two GENI boards, and a PDAD hard drive. It is situated on the R core of the EX2000 excitation control system. The fuel skid pressure signals are translated using an onboard 196 microprocessor, which is subsequently utilized to send and write the signals to the UCPB board. The control sequence software then applies these signals. It has numerous vertical and right-angled connectors, a lot of integrated circuits embedded into the board, resistor network arrays, jumper switches, capacitors, and resistors. BOARD REPLACEMENT PROCEDURE: Check that all power to the unit is off. Open the door of the unit by loosening the top middle thumb screw on the outside of the door. The UCIA is held in place by plastic snaps (holders) Before removing the UCIA/UCPB assembly from the holder, remove the GENI daughterboard(s) connected to the UCIA Disconnect all connectors involved Push the top of the UCLA board to release it. Carefully lift the assembly out from the bottom snaps. Install the new assembly by lining up the boards with the six plastic standoffs attached to the unit. Then, carefully seat both ends into the holder and snap it into place. If the daughterboard(s) were removed, replace and reconnect all cables, ensuring that they are properly seated at both ends.UC2000 MOTHER BOARD

IC697MDL740

IC670PBI001

IC698CHS117C

DS200TCQAG1BHF

IS200AEPCH1ABC

IC697MDL250

IC697MDL250

760-P1-G1-S1-LO-A20-R

SR489-P5-LO-A20-E

IC670CHS001E

IC697MDL653

IS200VTCCH1CBB

VMIVME-4150