DS3800HROA General Electric Relay output board

Part Number DS3800HROA Manufacturer General Electric Country of Manufacture As Per GE Manufacturing Policy Series Mark VI/VIe Function Module Availability In StockDS3800HROA is a Relay Output Board developed by GE. It is a part of Mark IV control system. The Mark IV control system is a type of control system used for gas and steam turbines, and it is designed to provide advanced control and monitoring capabilities. It is designed to operate within a 24 VDC power supply range and has a maximum output rating of 125 VAC/125 VDC at 5A per point. This board features a total of 24 outputs and is equipped with LED indicators that provide status information for each output channel. Mark VI Unit Configuration The Mark VI interface uses Ethernet Global Data messages for periodic data, and the ALM protocol for alarms and SOE messages. The information is transferred directly from the EGD global memory into PI, and the Digital Exception Messages go through the Historian System Service (HST). Configuration Files The Mark VI is configured primarily through a set of ASCII text files and the Toolbox file. These files are divided into several directories based on the functions performed.RELAY OUTPUT BOARD

About DS3800HIOA

GE input isolator board DS3800HIOA has a hole at each corner for mounting the board with screws inside the driver. GE input isolator board DS3800HIOA is also equipped with a microprocessor and several erasable programmable read-only (EPROM) modules. The board has a 34-pin connector that can be accessed from the front of the board. It also installed test points and a 40-pin connector on the surface of the circuit board.

Erasable programmable read-only (EPROM) modules are plugged into sockets embedded in the board. If you have replaced the boards in the drive, you can take them out of the slot. If firmware and code are updated with newer versions, they can also be deleted. Usually, the code is not updated, because once the board is installed and it successfully receives command signals and processing signals, the site continues to use the same version of programming code and firmware. However, if the board is replaced, the module will be removed. If the circuit board is defective, it can be replaced.

The replacement board was shipped without an EPROM module, so the maintenance personnel must remove the module from the defective board and install it on a new board. Find a short end of the module socket and insert a screwdriver between the socket and the module. Turn the screwdriver to loosen one end of the module. Repeat the above operation at the other end of the socket and put the module into the electrostatic protection bag.

DS200DCFBG1BLC

MS90376-12Y

VMIVME-7807RC

SERVOSTAR 310

IS200ERIOH1AAA

IS220PSCAH1A 336A4940CSP9

D20-PS LFDSC143-4000

IS200TDBTH6ABC

DS200SHVMG1AGE

IS2020RKPSG3A

DS200SHVMG1AFE

IC660ELB912

IS220PPRFH1A

IC698PSA350

HYDRAN M2

IC693PWR321

IS215VCMIH2BB IS200VCMIH2BCC