DS3800NADB 12-bit analog/digital converter printed circuit board

Part Number DS3800NADB Manufacturer General Electric Country of Manufacture As Per GE Manufacturing Policy Series Mark VI/VIe Function Module Availability In StockThe DS3800NADB is a 12-bit analog/digital converter printed circuit board. This PCB is part of the General Electric Speedtronic Mark IV family of gas and steam turbine control systems. All important controls and protection settings on the Mark IV are developed with integrated chipsets with two-out-of-three voting redundancy. The DS3800NADB is a bigger PCB that serves as a motherboard for the DS3800DADB, a smaller auxiliary board. Because of the eight capacitors (708A1 200V M/E) attached to the auxiliary, the capacitance of the DS3800NADB is considerably improved when this board is mounted. DS3800NADB has a spare PTH at its right edge. It has one amber LED with the letters "p ok" written on it. There are three TP test pots . The com/sync/aout tag is used to identify these. There is only one male connector and one female connector. It also has one ribbon connector for DS3800DADB communication. The board has already been drilled at the factory. Two variable resistor potentiometers are included. The upper and lower right corners have extractor tabs attached to them. It has a mark on it that indicates where it should be aligned. NADB 6DA02 6BA04 is written on the bottom border. There were a lot of jumper switches on it. "Range" is written on J1. J2 is labeled "parity" and can be toggled between in and out. J3 is labeled OSC and can be toggled between in and outmodes.12 BIT A/D CONV

About the DS3800NADB

The DS3800NADB is a printed circuit board designed as a 12-bit analog/digital converter card. This PCB is designed as a component of the Speedtronic Mark IV series, which is a gas and steam turbine control system from General Electric. The Mark IV is designed with integrated chipsets with intentional two-out-of-three voting redundancies on all critical controls and protection parameters.

The DS3800NADB is a larger PCB that functions as a motherboard to the smaller auxiliary board DS3800DADB. When this board is installed the capacitance of DS3800NADB is greatly increased due to the eight capacitors (708A1 200V M/E) attached to the auxiliary.

The DS3800NADB has the following specifications:

It has spare PTH located along its right edge.

It has one amber LED marked "p ok."

It has three TP test points. These are marked com/sync/aout.

It has one female connector.

It has one male connector.

It has one ribbon connector for communicating with DS3800DADB.

It is factory drilled.

It has two variable resistor potentiometers.

It has an extractor tab attached to its upper and lower right corners.

It is marked for alignment. It is marked on its bottom edge: NADB 6DA02 6BA04.

It had multiple jumper switches. J1 is marked "range." J2 is marked "parity" and can be set to in or out. J3 is marked OSC and can be set to in or out.

It has multiple integrated circuits.

All tech support for the DS3800NADB including publications such as manuals and data sheets was provided by GE.

IC697MDL740

IC670PBI001

IC698CHS117C

DS200TCQAG1BHF

IS200AEPCH1ABC

IC697MDL250

IC697MDL250

760-P1-G1-S1-LO-A20-R

SR489-P5-LO-A20-E

IC670CHS001E

IC697MDL653

IS200VTCCH1CBB

VMIVME-4150