DS3800XCIA Mark VI/VIe function module

Part Number DS3800XCIA Manufacturer General Electric Country of Manufacture As Per GE Manufacturing Policy Series Mark VI/VIe Function Module Availability In StockThe DS3800XCIA board is part of the Mark IV turbine control system from General Electric. This system, which is one of many Speedtronic systems available from GE, has been used for decades to monitor and regulate industrial gas and steam turbine systems. Multiple microprocessor-based controllers were used to build the Mark IV, which boosted the system's reliability. While the DS3800XCIA board has been phased out by the original equipment manufacturer, it is still available from WOC's extensive inventory of aftermarket General Electric replacement components. The DS3800XCIA board has a small number of components. Components are limited to two double-ported jacks at a single jumper cap on one short board edge. A single silver rail runs parallel to two lines of vertical pins on the other board edge. These go parallel to the edge of the board. The board's final components are three-terminal bars that run parallel to the board's long edges. Wiring connections can be made to various screw ports on these. The top and bottom edges of the board are severely drilled. The board is usually mounted using factory drill holes. Several codes and identification markers can be found on the board. More information regarding them can be found in GE manuals and product guides, as well as other related material. Before you unbox any part and undertake any installation, make sure you understand all handling procedures. It is not recommended to handle, maintain, or install this equipment without first reading and comprehending the related documented hazards.CARD

The DS3800XCIA board is part of the General Electric Mark IV turbine control system.  This system has been used for the management and control of industrial gas and steam turbine systems for many decades and is one of many Speedtronic systems available from GE.   The Mark IV was built using multiple microprocessor-based controllers, which increased the system’s reliability.   While the DS3800XCIA board has been discontinued by the original equipment manufacturer it remains available for purchase within AX Control’s vast stock of after-market General Electric replacement parts. 

The DS3800XCIA board is sparsely populated.  Components are limited to two double-ported jacks located on one short board edge, close to a single jumper cap.   The opposite board edge is taken up by a single silver rail running parallel to two lines of vertical pins.  These are parallel to the board edge.  The last components on the board are three terminal bars running parallel to the long board edges.  These have multiple screw ports available for wiring connections to. 

The board itself is heavily drilled along its top and bottom edges.  Factory drill holes are typically used for mounting the board.   The board is marked with several codes and identifying marks.  More information about these can be found through associated documentation like GE manuals and product guides.  Make sure you understand all handling procedures before you unbox your part and begin any installation.   Handling, maintenance, or installation of this equipment before reading and understanding the associated documented hazards is not advised.  

IC697MDL740

IC670PBI001

IC698CHS117C

DS200TCQAG1BHF

IS200AEPCH1ABC

IC697MDL250

IC697MDL250

760-P1-G1-S1-LO-A20-R

SR489-P5-LO-A20-E

IC670CHS001E

IC697MDL653

IS200VTCCH1CBB

VMIVME-4150