IS200EXCSG1A EX2100 excitation controller

Part Number IS200EXCSG1A Manufacturer General Electric Country of Manufacture As Per GE Manufacturing Policy Series EX 2100e Function Module Availability In StockIS200EXCSG1A is an Exciter Conduction Sensor Board manufactured and designed by General Electric as part of the EX2100 Series used in Excitation Control Systems. 

The EX2100 Excitation Control uses the IS200EXCS Conduction Sensor Board (EXCS) to detect bi-directional current flowing over a bus line. The IS200EGPA Exciter Gate Pulse Amplifier Board (EGPA) supplies the board with power, and it also filters the EXCS board's output before sending it to the IS200EMIO Exciter Main Input/Output Board (EMIO). The EXCS board detects current using two unidirectional Hall Effect sensors facing opposite directions. Depending on the existence of a magnetic field, these sensors generate a logical output. A logical low output is generated by the circuit when either sensor detects a magnetic field that is greater than the operating threshold of the sensor (indicating current). When the field dips below the release point, the sensor will continue to operate in this low output mode. Circuit Interconnect The board has gapped steel rings affixed to it in order to monitor current flow. 

These circles are traversed by the bus route.

The concentrated magnetic flux generated within the rings is measured by the Hall Effect sensors on the circuit board. The EXCS board is mounted directly to the bus line and the steel rings are held in place by a plastic mounting bracket. A power supply input of +12.0 V dc 5%, 0.3 watts at most, and a 12 V dc return is needed for the EXCS board. The EGPA board is the source of these. For redundancy, the EGPA board receives two identical logical output signals from the EXCS board. Logic high outputs are above 11 V dc while logical low outputs are less than 1.2 V dc. The 4-pin P1 connector is used to connect all inputs and outputs to the EGPA board. Three EXCS boards, one for each bus line, are powered by the EGPA board. It transfers the information to the EMIO board after filtering the output signals from each of the EXCS boards. APPLICATION DATA: The Power Conversion Module (PCM) cabinet holds the EXCS board, which is devoid of fuses, testpoints, LED indications, and movable hardware. P1 is the only 4-pin connector on the board.EX2100- CONDUCTION S Please contact us. Gmail: yy4291644@gmail.com   Enterprise mailbox: ivy@kongjiangauto.com 

Related models

0880001-01

104X905BA603

12A0-0103-A3

12HFA51A42H

12HGA11J52

269 PLUS-D/O-100P-125V

369-A200

369B1860G0026

369B1860G0030

369-C100

369-C101

369-HI-0-0-0-0

369-HI-0-M-F-E-0

369-HI-R-M-0-0-0-E

369-HI-R-M-0-E-0

369-HI-R-M-0-P-0-E