SAMSUNG SSAS-PRO SPTB-DI dedicated terminal board

SAMSUNG SSAS-PRO SPTB-DI is a dedicated terminal board designed to facilitate clear, reliable signal wiring between field discrete sensors and SSAS-Pro digital input modules (such as the SPDI-16 or SPDI-24).

Operating as an essential wiring interface within the Samsung SSAS-Pro (Ship Automation System Pro) architecture, the SPTB-DI streamlines field connections from switches, alarm contacts, and limit sensors.

It organizes signal distribution, simplifies panel layout, and offers point-to-point test access for efficient troubleshooting during marine and industrial automation commissioning.

Technical Parameter List

Product Features & Core Advantages

Streamlined Cabinet Wiring: Replaces messy point-to-point wiring with high-density organized terminal blocks, drastically reducing control panel assembly time.

Vibration-Proof Terminal Clamping: Built with high-retention spring or screw clamps engineered to prevent wire loosening under constant marine engine room vibration.

Simplified Maintenance & Diagnostics: Integrated test points allow technicians to measure field contact signals directly at the terminal board without disconnecting field wires.

Enhanced System Isolation: Isolates raw field wiring away from sensitive backplane electronics, serving as a clean boundary for field signal landing.

Model Classification

SSAS-Pro Terminal Board Series:

SPTB-DI: Terminal Board for Digital Input Modules (SPDI Series)

SPTB-DO: Terminal Board for Digital Output Modules (SPDO / SPRDO Series)

SPTB-AI: Terminal Board for Analog Input Modules (SPAI / SPRI Series)

SPTB-AO: Terminal Board for Analog Output Modules (SPAO Series)

Environmental Tolerance Conditions

Operating Temperature: -15°C to +55°C

Storage Temperature: -25°C to +70°C

Relative Humidity: 5% to 95% (non-condensing)

Vibration & Corrosion Resistance: Conforms to major marine classification society standards (DNV, ABS, LR, KR) for high-vibration and humid salt-spray environments.

Installation Method

DIN Rail Mounting: Snap the SPTB-DI terminal base securely onto a standard 35mm DIN rail inside the control cabinet.

Interconnect Cable Routing: Connect the dedicated multi-core ribbon or pre-fabricated cable from the SPTB-DI board connector to the corresponding slot on the SPDI digital input module.

Field Wiring Termination: Strip field wire ends (approx. 7–8 mm) and insert them into the designated channel terminals. Secure the screw/spring clamps firmly.

Shield Grounding: Clamp the overall shield of field cables to the cabinet earth grounding bar near the terminal board entry point.

Operating Instructions

Wiring Polarity Verification: Verify 24V DC contact power supply polarity across common terminal buses before applying power to field loops.

Signal Validation: Use a multimeter on the terminal test points to confirm field contact closures (open/short states) prior to system software commissioning.

Routine Servicing: Periodically inspect terminal torque during routine vessel maintenance to ensure high-vibration stability.