ABB 07KT98 H4 GJR5253100R3262

ABB 07KT98  H4 GJR5253100R3262

3BSC550038R3

TC501V150 Termination unit, 150 Ohm

3BSC610064R1

SD831 Power Supply, 3A

3BSC610065R1

SD832 Power Supply, 5A

3BSC610066R1

SD833 Power Supply, 10A

3BSC610067R1

SD834 Power Supply, 20A

3BSC610068R1

SS832 Power Voting Unit

3BSC630049R1

TC562 Short Distance Modem

3BSC690019R1

CIX539 AUI (10Base5) to BNC (10Base2)

3BSC690071R1

AI890 Analog Input IS 8 ch

3BSC690072R1

AO890 Analog Output IS 8 ch

3BSC690073R1

DI890 Digital Input IS 8 ch

3BSC690074R1

DO890 Digital Output IS 4 ch

3BSC690075R1

TU890 IS MTU

3BSC740007R1

Main Supply Filter 250V, 20A

3BSC740008R1

Main Supply Filter 250V, 55A

3BSC740009R1

Main Supply Filter 250V, 80A

3BSC840074R1

TC506 AF 100 Trunk Tap

3BSC840157R1

TU891 non-IS MTU

3BSC910044R1

Mounting Plate 24"

3BSC910048R1

Mounting plate 19"

3BSC930057R1

Filter Carpet for Subrack RF52x

3BSC950004R1

TK527V030 Interface cable

3BSC950055R1

General information and notes for the reader 

    Read these instructions carefully prior to installing and commissioning the device. 

    These instructions are an important part of the product and must be kept for later use. 

    These instructions are intended as an overview and do not contain detailed information on all designs for this product or every possible aspect of installation, operation and maintenance. 

    For additional information or in case specific problems occur that are not discussed in these instructions, contact the manufacturer. 

    The content of these instructions is neither part of any previous or existing agreement, promise or legal relationship nor is it intended to change the same.

    This product is built based on state-of-the-art technology and is operationally safe. It has been tested and left the factory in a safe, maintenance-free state.     The information in the manual must be observed and followed in order to maintain this state throughout the period of operation. 

    Modifications and repairs to the product may only be performed if expressly permitted by these instructions. 

    Only by observing all of the safety information and all safety/warning symbols in these instructions can optimum protection of both personnel and the environment, as well as safe and fault-free operation of the device, be ensured. 

    Information and symbols directly on the product must be observed. They may not be removed and must be fully legible at all times.