ABB 3HAC17326-1/02

ABB3HAC17326-1/02

Normally, the operating range is determined automatically during Autoadjust. A partial run of Autoadjust that is limited to the control parameters (CTRL_PAR, see parameter DANG_DN) or valves and fittings without end stops, however, requires manual adjustment of the operating range.

The range between high and low limit value must be at least 10% of the full range. Otherwise, the message VR<10% is displayed. 

Important 

Use as large are range as possible. This parameter is not active when the safe position is active. The display then shows the message FAIL_POS. 

You use MIN_VR to determine the lower limit of the operating range. 

up or down     Press in order to travel to the desired position. 

ENTER     Press and hold until the countdown is finished (MIN_SET). The position is taken over as min. limit value. 

ENTER     Press briefly. The set limit value is displayed for 2 seconds (MIN_SAVE).

3BUR002253R1

CS512K01 Comm Kit for Redund AC 400 DCN

3BUR002254R1

CS513K08 Communication Kit for Redundant

3BUR002262R1400

OPC Server, MOD 300 1.4 Inst and Config.

3BUR002268R14

OPC Server for MOD 300 1.4 Product Box

3BUR002321R1

PU514AK01 Communication Kit for Redundan

3BUR002336R3701

AdvaBuild 3.7 CCF User's Guide

3BUR002340R22

OPC Data Link 2.2 Product Box

3BUR002374R3701

AdvaBuild 3.7 MOD300 Eng. Displays U.G.

3BUR002375R3701

AdvaBuild 3.7 MOD300 Eng.Displ.Op U.G.

3BUR002378R1

AdvaControl Basic Software License for

3BUR002379R1

AdvaControl Software Incr. License for

3BUR002380R1

AdvaControl Software Incr. License for

3BUR002381R1

AdvaControl Software Incr. License for

3BUR002382R1

AdvaControl Basic Software Redundancy

3BUR002385R1

Basic SW PROFIBUS-DP Licence CPU 2