ABB 58967441 NTAC-02; PULSE ENCODER INTERFACE

Safety Instructions

Overview

This chapter states the safety instructions that must be followed when installing and operating the NTAC-0x/NDIO-0x/NAIO-0x Module. The material in this chapter must be studied before attempting any work on, or with, the unit.

Warnings and Notes

This manual distinguishes two sorts of safety instructions. Warnings are used to inform of conditions which can, if proper steps are not taken, lead to a serious fault condition, physical injury and death. Notes are used when the reader is required to pay special attention or when there is additional information available on the subject. Notes are less crucial than Warnings, but should not be disregarded.

Warnings

Readers are informed of situations that can result in serious physical injury and/or serious damage to equipment with the following symbols:

Dangerous Voltage Warning: warns of situations in which a high voltage can cause physical injury and/or damage equipment. The text next to this symbol describes ways to avoid the danger.

General Warning: warns of situations which can cause physical injury and/or damage equipment by means other than electrical. The text next to this symbol describes ways to avoid the danger.

Electrostatic Discharge Warning: warns of situations in which an electrostatic discharge can damage equipment. The text next to this symbol describes ways to avoid the danger.

Notes Readers are notified of the need for special attention or additional information available on the subject with the following symbols: CAUTION! Note: Caution aims to draw special attention to a particular issue. Note gives additional information or points out more information available on the subject.

General Safety Instructions

WARNING! All electrical installation and maintenance work on the drive should be carried out by qualified electricians.

The drive and adjoining equipment must be properly earthed.

Do not attempt any work on a powered drive. After switching off the mains, always allow the intermediate circuit capacitors 5 minutes to discharge before working on the frequency converter, the motor or the motor cable. It is good practice to check (with a voltage indicating instrument) that the drive is in fact discharged before beginning work.

The motor cable terminals of the drive are at a dangerously high voltage when mains power is applied, regardless of motor operation.

There can be dangerous voltages inside the drive from external control circuits even when the drive mains power is shut off. Exercise appropriate care when working with the unit. Neglecting these instructions can cause physical injury and death.

WARNING! There are several automatic reset functions in the drive. If selected, they reset the unit and resume operation after a fault. These functions should not be selected if other equipment is not compatible with this kind of operation, or dangerous situations can be caused by such action.

More Warnings and Notes are printed at appropriate instances along the text.

General Information

Product ID:58967441

ABB Type Designation:NTAC-02

Catalog Description:NTAC-02; PULSE ENCODER INTERFACE

Long Description:NTAC-02

Gross Weight:0.09 kg

Close to us.

ABB  asea brown boveri    A-B Allen-Bradley   Agilent  B&R  BEIJER  Fisher-Rosemount  Foxboro  Fujinon

GE Fanuc  Hitachi   Honeywell  Motorola  Moxa  (Siemens) Moore  Modicon  Mitsubishi  Metso  Matrox   National Instrument   NIKON  Okuma  Omron  Power Module  Phoenix  Reliance  SANYO  SIMODRIVE   Sumtak  Symantec  Seagate  Toshiba  Turck   Texas Instruments  Takaya   Westinghouse  XYCOM  VMIC   Yokogawa  Yaskawa  Yamatake