Ovation MVME6100 Single Board Computer Emerson

Flash Boot Bank Select Configuration Switch (S4)

A 4-position SMT configuration switch is located on the board to control Flash Bank B Boot block write-protect and Flash Bank A write-protect. Select the Flash Boot bank and the programmed/safe start ENV settings. It is recommended that Bank B Write Protect always be enabled. The Bank B Boot WP switch is OFF to indicate that the Flash Bank B Boot block is write protected. The switch is ON to indicate no write-protection of Bank B Boot block. The Bank A WP switch is OFF to indicate that the entire Flash Bank A is write-protected. The switch is ON to indicate no write-protection of Bank A Boot block. When the Boot Bank Sel Switch is ON, the board boots from Bank B, when OFF, the board boots from Bank A. Default is ON (boot from Bank B). When the Safe Start switch is set OFF, normal boot sequence should be followed by MOTLoad. When ON, MOTLoad executes Safe Start, during which the user can select the Alternate Boot Image

Installing the Blade

Procedure Use the following steps to install the MVME6100 into your computer chassis. 

 1. Attach an ESD strap to your wrist. Attach the other end of the ESD strap to an electrical ground (refer to Unpacking Guidelines). The ESD strap must be secured to your wrist and to ground throughout the procedure. 

 2. Remove any filler panel that might fill that slot. 

 3. Install the top and bottom edge of the MVME6100 into the guides of the chassis.

4. Ensure that the levers of the two injector/ejectors are in the outward position. 

 5. Slide the MVME6100 into the chassis until resistance is felt. 

 6. Simultaneously move the injector/ejector levers in an inward direction. 

 7. Verify that the MVME6100 is properly seated and secure it to the chassis using the two screws located adjacent to the injector/ejector levers. 

 8. Connect the appropriate cables to the MVME6100. To remove the board from the chassis, press the red locking tabs (IEEE handles only) and reverse the procedure.

Connecting to Peripherals

When the MVME6100 is installed in a chassis, you are ready to connect peripherals and apply power to the board

Completing the Installation

Verify that hardware is installed and the power/peripheral cables connected are appropriate for your system configuration. Replace the chassis or system cover, reconnect the system to the AC or DC power source, and turn the equipment power on