General Electric IC3600KVSA1 Zero-speed relay board

Part Number IC3600KVSA1 Manufacturer General Electric Country of Manufacture As Per GE Manufacturing Policy Series Mark VI/VIe Function Module Availability In StockGE Developed IC3600KVSA1 as Zero Speed Relay Board under Mark I or II series. General Electric's Speedtronic turbine management systems, Mark I and Mark II, are both available. They were designed to serve five main purposes. These functions include limiting the turbine maximum output to within the unit's capability, protecting the turbine in the case of a non-recoverable system failure inside the system, and controlling the turbine output power over its load range. For a startup, the turbine control settings and auxiliaries must be sequenced. Failures in the gas turbine, its auxiliaries, and the control system are monitored and reported. The IC3600KVSA1 is designed with a single-reed relay in the middle. Reed relays are fast, tiny, and lightweight devices that employ an electromagnet to control a reed switch. This is a GE reed relay with the following specifications: Coil 28 VDC, Cont. 50 VA, NP 68A99729P2. On the upper surface of the relay, there is a relay schematic. Multiple wires connect the relay to the line of pins on one edge of the board. There is only one trim potentiometer on the board. On its surface are five transistors of two sorts. Each transistor is clearly labeled. Carbon composite resistors and ceramic and aluminum electrolytic capacitors are used on the board. The diodes are labeled. On the board, there is only one integrated circuit. A single line of metal pins is attached to one side of the card. These pins will be linked into the Speedtronic system as a communication device.ZERO-SPEED-RELAY

IC3600KVSA1 has a reed relay in the center of the card. Reed relay uses electromagnet to control reed switch, which is often fast, small and light. This is Agger reed relay, marked as 68A997168A02, coil 28 VDC, continue. 50 VA，NP 68A99729P2。 The relay diagram appears on the upper surface of the relay. The relay is connected to a pin line located at one side of the circuit board through a plurality of wires.IC3600KVSA1 has a fine-tuning potentiometer. There are five transistors of two types on its surface. Every transistor has a tag. The board uses carbon composite resistors and ceramic and aluminum electrolytic capacitors. Diodes are marked. There is an integrated circuit on the board.IC3600KVSA1 has a row of metal pins connected to one side of the circuit board. These pins act as communication devices and will be connected to the Speedtronic system.

IC697MDL740

IC670PBI001

IC698CHS117C

DS200TCQAG1BHF

IS200AEPCH1ABC

IC697MDL250

IC697MDL250

760-P1-G1-S1-LO-A20-R

SR489-P5-LO-A20-E

IC670CHS001E

IC697MDL653

IS200VTCCH1CBB

VMIVME-4150