IS220PPDAH1A GE Manufacturing Policy Series Mark VIe

Power Distribution Feedback board IS220PPDAH1A is part of the Mark VIe Turbine Control System Series which was produced by General Electric. The advent of the Mark VIe Series in the mid 2000s represented a significant upgrade in potential applications of the Mark product series from General Electric, as the Mark V Series was limited to gas and steam turbine applications alone, shirking any potential alternative energy settings. While lauded for its potential wind turbine setting usages, the Mark VIe Series that this IS220PPDAH1A Power Distribution System Feedback Unit belongs to is also considered an attractive option on the greater general automated industrial marketplace as it is one of the last-developed GE Mark product series to incorporate the patented Speedtronic control system technology across a range of its various product iterations, including this IS220PPDAH1A Power Distribution System Feedback Unit featured here.

The IS220PPDAH1A board uses electronic IDs to determine power distribution information, the information will then be used to populate the IONet outputs and provide the correct information and feedback to the conjoining boards. Please note that when the IS220PPDAH1A board is used in applications reading two hundred forty volts of alternating current it should not cross-connect with the volts of direct current; when this occurs the peak voltage will exceed the MOV rating and cause a failure. Failures occur as most of the alternating current supplies must operate on a grounded neutral. As outlined in the various instructional manual materials embedded in the manuals tab above for your convenience of research, this IS220PPDAH1A product does not take direct protective actions when faced with a functional fault or failure; it instead opts to report diagnostic information to respective Mark VIe Series system controllers where the true corrective action should have been pre-programmed.