200-510-071-113 200-510-111-034 Vibro-Meter VM600 system and sensor technical data.

Technical data of VM600 system and sensor of Vibro-Meter company in Switzerland

Machine monitoring and protection module

trait

From Vibro-Meter® product line

Continuous online machine protection card

Advanced DSP technology for real-time measurement and monitoring.

4 programmable inputs (such as vibration, displacement, etc.)

And two programmable speed/phase inputs.

Programmable broadband and narrowband filters

Monitor amplitude and phase synchronously according to order.

Programmable alarm, shutdown and OK values.

The alarm and shutdown values can be set adaptively according to the rotation speed.

Front panel BNC interface facilitates original signal analysis.

Seven front panel LEDs display status and alarm.

Provide working power for various sensors such as acceleration, speed and eddy current.

Support hot plug.

describe

MPC4 machine protection card is the core component of the VM600 machine protection system of Vibro-Meter company.

This flexible card can measure and monitor four dynamic signal inputs and two speed/phase signal inputs at the same time. When the dynamic signal is input.

Fully programmable, can receive acceleration, speed and displacement signals or other signals. Multi-channel processing technology on the board can realize various physical measurements, such as relative

Shaft vibration, absolute shaft vibration, SMAX, eccentricity, shaft displacement, absolute and relative expansion, dynamic pressure, etc. The speed/phase input can be connected with various speeds.

Sensors (such as eddy current, reluctance, TTL, etc.) support fractional speed ratio.

MPC has powerful digital processing functions, including digital filtering, digital integration or differentiation, and digital modulation (root mean square, average, peak value, peak-to-peak value, etc.).

Frequency order tracking (amplitude and phase) and sensor gap measurement.

The output unit is set in metric or English software, and the alarm and shutdown values are completely programmable, including alarm delay, dead zone