PC-E984-381 and PC-E984-385/385D logic controller system and system planning and installation.

Системы логического контроллера PC-E984-381 и PC-E984-385/385D, а также планирование и установка системы.

This guide describes the PC-E984-381 and PC-E984-385/385D Programmable Logic Controller systems together with system planning information and installa- tion procedures. For brevity and your convenience, the PC-E984-381/385 controller is referred to in context as the Model 381 E or 385E. Both Model 381 E and 385E are enhanced with an extra Modbus Port.. The 385D is a 125 VDC version which is otherwise just like a 385E. In the context of this manual, the terms “Programmable Controller” and “Program- mable Logic Controller” have been abbreviated to “PLC” for brevity. References to IBM’s personal computer are written out or in context with IBM’s initials. It is necessary to say that the information in this document is subject to change without notice and should not be construed as a commitment by MODICON, Inc., Industrial Automation Systems. MODICON, Inc. assumes no responsibility for any errors that may appear in this document. Further, no part of this document may be reproduced in any form or by any means, electronic or mechanical, without the ex- press written permission of MODICON, Inc., Industrial Automation Systems. All rights reserved.

Objectives

This manual has been written to help you plan, configure, mount, wire, connect, check out and, if necessary, troubleshoot your PC-E984_381/385/385D PC sys- tem. After reading this publication: A Control Engineer will be able to identify and physically plan the location and mounting of system components. A Plant Electrician/Installer will be able to install, power-up and check out the system. A Maintenance Technician will be able to recognize, locate, identify and resolve or report system failures.

How To Use This Manual

Chapter 1 describes the E984-38x model PC system’s functions. Chapter 2 offers information for planning your installation with Local I/O. Chapter 3 is an installation procedure for your controller with local I/O. Appendix A gives system specifications including a summary table of l/O module specifications. Appendix B gives Stopped Error Codes, MODBUS cable connector pinouts, a table of MODICON 381 E/385E/385D system end-user part numbers, Customer Service/Technical Support telephone numbers, and Installation Verification trouble- shooting charts.

Related GM-MSFT-001 GM-0984-SYS Documents

Incoming Inspection Guidelines Procedure Step 1 Step 2 li7 Note Guidelines for inspection Before you do anything, verify your shipment is com- plete and undamaged. If the shipment is incomplete or damaged, notify the carrier and your distributor. Remove everything from its packing and check for physical defects or damage. If the equipment is physically defective or damaged, notify your MODICON representa- tive. Save shipping materials until installation is complete. Sending Something Back? o o o To the extent possible, use the original packing materials supplied by MODICON. All equipment should be firmly packed so that it cannot move around in its ship- ping container. All equipment should be protected against impact during shipment.