Woodward 2301A Electronic Load Sharing and Speed Control 9905/9907 Series

Woodward 2301A Electronic Load Sharing and Speed Control  9905/9907 Series 

Description

The 9905/9907 series of the Woodward 2301A controls load sharing and speed

of generators driven by diesel or gasoline engines, or steam or gas turbines.

These power sources are referred to as “prime movers” throughout this manual.

The control is housed in a sheet-metal chassis and consists of a single printed

circuit board. All potentiometers are accessible from the front of the chassis.

The 2301A provides control in either isochronous or droop mode.

The isochronous mode is used for constant prime mover speed with:

Single-prime-mover operation;

Two or more prime movers controlled by Woodward load sharing control

systems on an isolated bus;

Base loading against an infinite bus with the load controlled by an Automatic

Power Transfer and Load (APTL) Control, an Import/Export Control, a Generator

Loading Control, a Process Control, or another load-controlling accessory.

The droop mode is used for speed control as a function of load with:

Single-prime-mover operation on an infinite bus or

Parallel operation of two or more prime movers.

The following is an example of the typical hardware needed for the 2301A

system controlling a single prime-mover and generator:

A 2301A electronic control

An external 20 to 40 Vdc power source for low-voltage models; 90 to 150

Vdc or 88 to 132 Vac for high-voltage models

A proportional actuator to position the fuel-metering device, and

Current and potential transformers for measuring the load carried by the

generator.

Applications

The 2301A 9905/9907 series electronic controls have switch-selectable speed

ranges. Any of these control models can be set to operate within one of the

following rated speed ranges:

500 to 1500 Hz

1000 to 3000 Hz

2000 to 6000 Hz

4000 to 12 000 Hz

These controls are available for forward- or reverse-acting applications, and for

use with either single or tandem actuators. Models for three different actuator

current ranges are available, as well as a high-voltage model (90 to 150 Vdc or

88 to 132 Vac, 45 to 440 Hz), and a low-voltage model (20 to 40 Vdc). The high

voltage model is identified as such on the front; the low voltage model is not.

In reverse-acting systems, the actuator calls for more fuel when the actuator

voltage decreases. Complete loss of voltage to the actuator will drive the actuator

to full fuel. This allows a backup mechanical ballhead governor to take control

rather than shut down the prime mover as would a direct-acting system.

An optional deceleration ramp is also offered. When this option is present, the

time to ramp from rated speed to idle speed is approximately 20 seconds. If this

option is not present, this happens instantly.

Tables 1-1 and 1-2 show part numbers and features of all 9905/9907 series

2301A load sharing and speed controls.

The relationship between prime mover speed and sensor output frequency is

expressed in the formula:

Sensor Frequency in Hz equals the number of teeth on the speed

sensing gear times the rated prime mover speed in revolutions per

minute divided by 60.

Application engineers from Woodward or any of its authorized distributors or

agents are always available to assist you in selection of the correct control for

your system, or to answer questions concerning control installation, operation, or

calibration. See Chapter 6 for contact information.

References

The following publications contain additional product or installation information on

Load Sharing and Speed Controls, and related components. They are available

on the Woodward website (www.woodward.com/ic).

technical

manual   title

25070    Electronic Governor Installation Guide

26260    Governing Fundamentals and Power Management

82384    SPM-A Synchronizer 9905-002

82510    Magnetic Pickups & Proximity Switches for Electronic Controls

82715   Guide for Handling and Protection of Electronic Controls, Printed

Circuit Boards, and Modules

product

specification  title

82383    SPM-A Synchronizer

82390   2301A Load Sharing and Speed Controls (9905 Series)

82516    EG3P/6P/10P Actuator

82575     EGB1P/2P Governor/Actuator