ABB 3HAC5498-1

ABB 3HAC5498-1

3BSE089151R0056

5,000 Points, OPC Server, MOD 300 1.4

3BSE089151R0057

10,000 Points, OPC Server, MOD 300 1.4

3BSE089151R0058

20,000 Points, OPC Server, MOD 300 1.4

3BSE089151R0059

30,000 Points, OPC Server, MOD 300 1.4

3BSE089151R0061

AE License, OPC Server for MOD 300 1.4

3BSE089151R0333

ABB Internal License OPC Server, MOD 300

3BSE089152R0052

Expand from 100 to 250 OPC Points

3BSE089152R0053

Expand from 250 to 500 OPC Points

3BSE089152R0054

Expand from 500 to 1,000 OPC Points

3BSE089152R0055

Expand from 1,000 to 2,500 OPC Points

3BSE089152R0056

Expand from 2,500 to 5,000 OPC Points

3BSE089152R0057

Expand from 5,000 to 10,000 OPC Points

3BSE089152R0058

Expand from 10,000 to 20,000 OPC Points

Important 

All control parameters are determined in an optimum way for most actuators during Autoadjust. Changes should only be made when Autoadjust cannot be executed or control stability cannot be achieved. 

The KP value is the gain of the controller. The control speed and stability are influenced by the KP value. With higher KP values, the controlling speed increases. 

Important 

The control precision is not affected by the KP value. 

To compensate for existing dissymmetries in the controlled system, the KP value should be set separately for both directions (up/down). 

For most actuators, a satisfactory control response is achieved with a KP value between 2.0 and 10.0. 

You can use parameter KP DN to adjust the KP value for the positioning direction down (towards 0 %).